posted this up in the terminator engine/tuning section with no replys so figured id try here.
mods are in sig and specifics tested are as read in paragraph below.
so i just installed my 2.6kb/jlt next gen high boost/ sct BA3000 all parts are used. I loaded up my tune (using email tunes to work out the bugs then going to a shop once i move across the country in a month so as to not waste money needing a retune for the new environment) and the car will start and immediately die after trying to idle for about 10-20 seconds failing miserably. when i unplug the maf though it idles perfectly fine. i even tried with the maf in a jlt short ram and same issue. now if i load up an older eaton tune with my BA 2800 installed car idles fine. im trying to determine if its the tune to blame or if its the maf that is the issue. how can i accurately check to see which is the problem?
thanks for the help
-steve
mods are in sig and specifics tested are as read in paragraph below.
so i just installed my 2.6kb/jlt next gen high boost/ sct BA3000 all parts are used. I loaded up my tune (using email tunes to work out the bugs then going to a shop once i move across the country in a month so as to not waste money needing a retune for the new environment) and the car will start and immediately die after trying to idle for about 10-20 seconds failing miserably. when i unplug the maf though it idles perfectly fine. i even tried with the maf in a jlt short ram and same issue. now if i load up an older eaton tune with my BA 2800 installed car idles fine. im trying to determine if its the tune to blame or if its the maf that is the issue. how can i accurately check to see which is the problem?
thanks for the help
-steve