What's up guys! I'll be installing a 15% lower on my 07. Any special modifications any special instructions to do it?
Sent from my Z982 using the svtperformance.com mobile app
Sent from my Z982 using the svtperformance.com mobile app
How to install 15% IW on a 2007 GT500?
- Thread starter svts197jag
- Start date
Right here on SVTP. Oldie but goodie. The guide for many of us that have done this mod.
Throwing a lot of boost at that TVS setup. Love it. Ever around State College with that beast, shoot me a PM.
https://www.svtperformance.com/foru...-up-installation-of-iw-10-od-balancer.461616/
Throwing a lot of boost at that TVS setup. Love it. Ever around State College with that beast, shoot me a PM.
https://www.svtperformance.com/foru...-up-installation-of-iw-10-od-balancer.461616/
IW has some pretty detailed install and crank sensor mounting boss modification instructions on their website. Ford 5.4L/5.8L Mod Motor Harmonic Damper for Shelby GT500 with 15% Overdrive Pulley | Racing Balancer | Innovators West
The crank sensor mounting boss modification is required for clearance of the balancer and the belt.
The crank sensor mounting boss modification is required for clearance of the balancer and the belt.
Thank you IronTerp!!! Nice write-up!! Definitely will get in touch with you when I'm around State college. The car should pull really good when I'm done with it. Thanks again!
Sent from my Z982 using the svtperformance.com mobile app
Just cut slow when doing the mounting boss. Dont want to cut it off if your using a 3 or 4" cut off wheel
Here is something that may be of interest to also install, while you are there........
2007-2014 GT500 Crank Saver Instructions – KINETIK MOTORSPORT
This is the kit linked above....
Shown below is a 10% and in the bag is the new IW crank bolt to replace the original, and a longer bolt that I purchased that is needed as a "tool" to start the balancer on the end of the crank shaft......
A closer bolt comparison, one for replacement of the original torque yield oem bolt and the longer for use as an install tool.....
R
2007-2014 GT500 Crank Saver Instructions – KINETIK MOTORSPORT
This is the kit linked above....
Shown below is a 10% and in the bag is the new IW crank bolt to replace the original, and a longer bolt that I purchased that is needed as a "tool" to start the balancer on the end of the crank shaft......
A closer bolt comparison, one for replacement of the original torque yield oem bolt and the longer for use as an install tool.....
R
Last edited:
Users who are viewing this thread
