• Welcome to SVTPerformance!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

How to launch at track manual trans 275/60 Hoosier drag radials Kevlar clutch?

Discussion in 'Drag Racing' started by venom1997, Mar 6, 2016.

  1. venom1997

    venom1997 Screwed by the Twins Established Member

    May 29, 2008
    albuquerque new mexico
    How should I launch to avoid any breakage I hear slipping and preloading no dumping like a bias even tho the Hoosier wrinkle like crazy. Also using a spec Kevlar clutch
  2. TTUhouston

    TTUhouston Mechanical Engineer Established Member

    Mar 22, 2017
    my 96 trans am with 100 shot was able to pull 1.6s with very similar HP/TQ. [email protected] was my best but I also had a spec stage 2 kevlar and hoosier QTPs on 15s. Just drop that psig and be careful at the top end, my tires would start walking at 120mph and scared the hell outta me; could have been my suspension though.

    What I was doing was slip through the first few miliseconds of the launch then sa soon as you are moving drop it fully (if that makes sense). Good luck!!

Share This Page