Got more than a few emails on how I did this so here's a step by step.
1. Unplug battery or pull #5 fuse from under hood.
2. Tap into hotwire on power point.
3. Run hotwire you just connected to one terminal of the master switch. I forget which one I did but there's only two to pick from.
4. Run another wire from the other terminal on the master switch to the foot switch as shown. Again, I forgot which terminal on the footswitch it is but there's only two.
5. Connect another wire to the remaining foot switch terminal and run it between the tunnel and dash to the passenger side. Connect this wire to one of the solenoid wires via butt connector.
6. Install a "circle" connector on the other wire and ground to stud shown. I put a washer between the plastic part and the circle connector.
I'll look more at it later since I'm late but this should help.
1. Unplug battery or pull #5 fuse from under hood.
2. Tap into hotwire on power point.
3. Run hotwire you just connected to one terminal of the master switch. I forget which one I did but there's only two to pick from.
4. Run another wire from the other terminal on the master switch to the foot switch as shown. Again, I forgot which terminal on the footswitch it is but there's only two.
5. Connect another wire to the remaining foot switch terminal and run it between the tunnel and dash to the passenger side. Connect this wire to one of the solenoid wires via butt connector.
6. Install a "circle" connector on the other wire and ground to stud shown. I put a washer between the plastic part and the circle connector.
I'll look more at it later since I'm late but this should help.