What is needed to log boost with the gauge?
HP tuners N gauge...Boost log
- Thread starter blownby
- Start date
Lund makes a "boost box" that connects to the ngauge to log boost. However i'm not sure if it works with just his ngauge or with the other HP tuners ngauge. I have it on my car and it works great.
I saw that, just wasn't sure it was compatible as well or if there was another option.
Well Lund replied and not compatible
you want to use one of the 0-5v inputs to log your boost. So go buy a electronic boost sending unit, tie it into your boost source, then run the 0-5v signal to the nGuage.
Something like this would work:
-30vac to 35 PSI
http://prosportgauges.com/electric-boost-sender-15.aspx
http://e-motionproducts.com/updates/nGauge/nGauge_Manual.pdf
Page 16 talks about analog inputs, use that in combination with the boost sending unit to get boost to work
Something like this would work:
-30vac to 35 PSI
http://prosportgauges.com/electric-boost-sender-15.aspx
http://e-motionproducts.com/updates/nGauge/nGauge_Manual.pdf
Page 16 talks about analog inputs, use that in combination with the boost sending unit to get boost to work
Last edited:
I already have an analog sending unit from my Autometer boost guage. Just need to know what wires to tap or use and then how to connect to the nGuage as they are just bare pins?
You would need a female pin connector that works with that size pin...unless they sell a harness that connect there that you can tie into
Radio Shak for the connector?
Users who are viewing this thread
