I've been porting cylinder heads for a long time and I've owned coyote cars, but never got around to working on the heads/intakes on them. Recently, I agreed to port a set of heads and an intake for a friend of mine who has a procharged coyote swapped fox.
I was able to find some very good gains on the cylinder heads, and while I didn't test the intake manifold on the flow bench, I believe there are some decent improvements to be had over a stock manifold.
Non-Vendor.
Here are some photos of the port work. Note: I haven't gone over everything with a sandpaper roll to smooth it out yet. Just showing the reshaping of the runners and inlet.
I was able to find some very good gains on the cylinder heads, and while I didn't test the intake manifold on the flow bench, I believe there are some decent improvements to be had over a stock manifold.
Non-Vendor.
Here are some photos of the port work. Note: I haven't gone over everything with a sandpaper roll to smooth it out yet. Just showing the reshaping of the runners and inlet.
Last edited by a moderator: