Is this blower a direct plug and play? I have a Gen 2 Whipple 2.9 Crusher now and there were a flew small modifications I had to do to get it to fit perfect.
When I installed the Gen 2 Crusher... I mean stuff was tight, but it's good now. I had to install the "Cobra Engineering IAC Relocator Plate," had to notch the underside hood, had to make injector harness extensions for the injectors under the crusher inlet for ease of connect/disconnect etc. It was sorta a pain in the beginning.
...and now
I'm debating on picking up a Gen 5 Whipple 3.0, and I haven't really heard or seen people posting about "installing them specifically." Also, I'm wondering since I already have a Crusher unit on my car, would I need to re-tune my car or not? I'd still be using all the same MAF & fuel stuff.
Thanks.
When I installed the Gen 2 Crusher... I mean stuff was tight, but it's good now. I had to install the "Cobra Engineering IAC Relocator Plate," had to notch the underside hood, had to make injector harness extensions for the injectors under the crusher inlet for ease of connect/disconnect etc. It was sorta a pain in the beginning.
...and now
I'm debating on picking up a Gen 5 Whipple 3.0, and I haven't really heard or seen people posting about "installing them specifically." Also, I'm wondering since I already have a Crusher unit on my car, would I need to re-tune my car or not? I'd still be using all the same MAF & fuel stuff.
Thanks.