I just installed new fron break pads on my 2003 Cobra and it seems to me that they are rattling like crazy when I go over any kind of bump. After they heat up, the rattle goes away? What could be causing this?
Just installed new front break pads and the breaks rattle like crazy!!!
- Thread starter 03GREYCOBRA
- Start date
Um try replacing the hardware.
Do you think it is the pins that hold the caliper in the bracket?
The pads in the caliper. Most of the hardware isn't designed to be taken out and put back in.
so everyone who replaces break pads on Cobras has to replace the entire breaks?
Ok. What did you remove to take the front pads out? What held them in?
The pads just snap in. I removed a c-clamp sort of thing to remove the pin that holds the caliper in the bracket.
brake, not break
03GREYCOBRA said:
Yeah those really really aren't designed to be used over again.
Some people can get by but some can't.
what can't be used over and over again? the pins?
if the pins, can i get them from the ford dealership
Oh yeah. and the clip.
Thanks for the link. I can't stand the rattle anymore!
Users who are viewing this thread
