Kenne Bell BAP question

[Strikeking10]

So I ordered a BAP but after getting it and looking at the instructions I cant figure out what the plug on the side is for, I also didnt get a adjuster with the kit, this is the one I ordered http://www.latemodelrestoration.com/item/KB-89069/Kenne-Bell-Boost-A-Pump-Single-40amp

Did I order the wrong one?

 

[Rich'sTRsvt]

Not sure, someone else on here has one without an adjuster too. You may have to call Kenne Bell and see what is going on.

 

[Strikeking10]

anyone else use the same one?

 

[Blueline]

That's the correct one. KB no longer sells them with the adjuster knob, they are set to run at 17.0-17.3volts all the time. That plug on the side was for the adjuster, just disregard it.

 

[wickedcobra99]

I recently bought the same one also plus the wire upgrade. It runs all the time. It seems to be working without issue thus far.

 

[Wicked46]

As mentioned, theres no reason for the adjuster. It's made to run full time and its better that way.

 

[Strikeking10]

As mentioned, theres no reason for the adjuster. It's made to run full time and its better that way.

Awesome that's what I needed to know, thank you

 

[Strikeking10]

Had a random thought, the BAP I got is the single 40amp because that's what I read I needed, is the dual one the correct one for the stock dual pump set up?

 

[R.D.P.]

Had a random thought, the BAP I got is the single 40amp because that's what I read I needed, is the dual one the correct one for the stock dual pump set up?

Nope - you only need the single, but you do need to do the wire upgrade also. Stock wiring isn't made to handle that juice.

 

[Strikeking10]

Nope - you only need the single, but you do need to do the wire upgrade also. Stock wiring isn't made to handle that juice.

I did get the wire upgrade as well, thank you