Have you read if replacing the electronics fix the issue? That’s all I can think is mechanical to fix
Sent from my iPhone using Tapatalk
No, sadly some bailed out on the 168 in frustration.........The others, I never heard an outcome.....
R
Have you read if replacing the electronics fix the issue? That’s all I can think is mechanical to fix
Sent from my iPhone using Tapatalk
crossing my fingers then.No, sadly some bailed out on the 168 in frustration.........The others, I never heard an outcome.....
R
crossing my fingers then.
When i received the TB from Kenne Bell i read the instructions and came with a tinny Ziploc bag with the bushings and the tool to adjust the spring. I thought this was standard procedure until i started reading about it that was an update. It makes total sense that is needed to avoid the plastic case cover binding once is put together.You have done the trouble shooting well beyond many, and this is the first thread where I have added the KB TB update info. that I know about. It was not until recently (the last couple of years) that I knew anything about KB TB updates..........
R
I just installed my 2.8LC kit in March. I have the dual 75mm TB and it came with an addendum and the two small bushings for the screws. After install, everything runs good. I would assume that I have the latest update.You have done the trouble shooting well beyond many, and this is the first thread where I have added the KB TB update info. that I know about. It was not until recently (the last couple of years) that I knew anything about KB TB updates..........
R
I just installed my 2.8LC kit in March. I have the dual 75mm TB and it came with an addendum and the two small bushings for the screws. After install, everything runs good. I would assume that I have the latest update.