• Welcome to SVTPerformance!

Looking For a CSRA Member With a Welder

Discussion in 'Georgia' started by Revvv, Apr 13, 2018.

  1. Revvv

    Revvv Infinity Poster Established Member

    Messages:
    10,190
    Joined:
    Dec 8, 2017
    Location:
    GA
    I need to make a few exhaust adjustments. I am not interested in paying an exhaust shop the price of a new exhaust to move my Flowmaster Super 10s around a bit and get the tips set where they belong.

    Plus It would be enjoyable to hang around and meet a fellow SVTP member.



    Sent from my [device_name] using the svtperformance.com mobile app
     
  2. GodStang

    GodStang Well-Known Member Established Member

    Messages:
    14,293
    Joined:
    Aug 20, 2003
    Location:
    Aiken, SC
    If I remember you are not on FB. i will ask around and see if there is anyone. For our custom setups we take our lay out pipes marked to a welder in New Ellenton and have him Weld it for us. Ends up being really cheap and since no one has a 3" SS bender in the area this is my only choice.
     
  3. Revvv

    Revvv Infinity Poster Established Member

    Messages:
    10,190
    Joined:
    Dec 8, 2017
    Location:
    GA
    No, I'm not on Facebook. I also do not need a pipe bender. I am basically looking to move the Super 10s back a few inches to better clear the drive shaft. Then I need to shorten the exhaust a bit to sit even with the bumper cut outs.

    Sent from my [device_name] using the svtperformance.com mobile app
     
  4. Revvv

    Revvv Infinity Poster Established Member

    Messages:
    10,190
    Joined:
    Dec 8, 2017
    Location:
    GA

Share This Page