Hey guys, decided to finally finish a project started by myself and pops way back in 2013 and has sat in the garage since. Does anyone have the plans/measurements/dimensions or pictures for the custom brackets needed to mount the OEM shaker to the 2V motor. I have the complete shaker set up, OEM Ford brackets and all. I have searched the internet for 2 weeks and have only found grainy old pictures from 10 years ago. Thanks for any help.
Mach 1 Shaker Brackets for 2V 03 GT
- Thread starter limited04
- Start date
Did CDC make a kit for two valves? I’d look into that
I believe CDC did make something, but I have the complete OEM Ford Mach 1 Shaker setup including the front air intake. I am looking for some dimensions on the old Kar Kraft brackets or custom brackets to mount the Ford Shaker System.
IMO the CDC was meh at best. I don't think I've seen a stock shaker on a 2V around here. I'm thinking you're going to have to break out the measuring tape and cardboard.
Users who are viewing this thread
