MM bushing install EASIER?

[Corner-Carver]

Would doing a rear spring change at the same time make it any easier in installing the MM bushings? Basically dropping the springs, replacing the bushings, then replaceing the springs.

Just wonder ing since everyone is almost willig to give up their firstborne for doing the install.

:read:

 

[toofast4u]

No it won't make it really easier. The hardest part is removing the old bushings. Removing the springs might make installing the assembly a little easier.

 

[Corner-Carver]

That's what I figured. Atleast PART of it would go easier.

 

[RedfireVenom]

The problem is that the old bushings are glued in. You can't just pop them out. You have to drill them out, then sand down the surfaces to remove the glue/debree.