So I spoke with Moser and I will be moving forward with the M9 rear:
05-14 Mustang Hsg & Axle Pkg
4 -Channel ABS W/ Excitor Rings
Moser Aluminum Case
Truetrac Posi 35 Spline
Alum. Daytona Support
Setup Kit 28 Spline Pinion
1350 Pinon Yoke - Steel
Pro Street Gear - 3.50 - 4.57
Currently have full BMR underneath and Viking shocks. I guess my question is to see if I have everything I need to bolt it up.
So aside from the M9, I will get the BMR 9 inch UCA, BMR panhard bar relocation bracket so it clears case. Driveshaft I was going with ActionMachine, still not entirely sure on the driveshaft specifics. But other than those things I think that is all that is needed to bolt it up in there.
Thanks!
05-14 Mustang Hsg & Axle Pkg
4 -Channel ABS W/ Excitor Rings
Moser Aluminum Case
Truetrac Posi 35 Spline
Alum. Daytona Support
Setup Kit 28 Spline Pinion
1350 Pinon Yoke - Steel
Pro Street Gear - 3.50 - 4.57
Currently have full BMR underneath and Viking shocks. I guess my question is to see if I have everything I need to bolt it up.
So aside from the M9, I will get the BMR 9 inch UCA, BMR panhard bar relocation bracket so it clears case. Driveshaft I was going with ActionMachine, still not entirely sure on the driveshaft specifics. But other than those things I think that is all that is needed to bolt it up in there.
Thanks!