Well I just installed my w/b comander and I set the guage to 11 like speedhut says and the guage goes straight to 18 and stayes there any ideas? The only wires i hooked up were the purple to the yellow for the guage and the power and ground. I was told that all i needed to use.
Need HELP! Dyno Jet w/b and Speedhut Guage!
- Thread starter Vmnous285
- Start date
White/Yellow(0-5v analog out) wire from the WBC needs to go to the yellow wire on the gauge.I also highly recommend you ground the DJWBC directly to the battery.I`m running the exact same set-up.
Edit
This is the DynoJet Wide Band Commander and not the DJ WB 2 correct?
Edit
This is the DynoJet Wide Band Commander and not the DJ WB 2 correct?
Last edited:
Users who are viewing this thread
