My goal is to get the other mods done before changing the pulley, hopefully close to 500 rwhp. so far i have done the CAI and the Cat Back so what I have left , I guess, is:
throttle body and inlet
x-pipe
headers (?)
programming/chip
so the question is do i get the headers, because that effects the x-pipe decision. I was waiting for the throttle body stuff until the jury is out on the different options (billetflow or JDM or whatever) because that is the least bang for the buck.
Once everything is in place, then I will get the chip. I'll probably hang out for a while and then install the 2.8 pulley to make sure I at least use some of the warranty.
any thoughts? thanks
throttle body and inlet
x-pipe
headers (?)
programming/chip
so the question is do i get the headers, because that effects the x-pipe decision. I was waiting for the throttle body stuff until the jury is out on the different options (billetflow or JDM or whatever) because that is the least bang for the buck.
Once everything is in place, then I will get the chip. I'll probably hang out for a while and then install the 2.8 pulley to make sure I at least use some of the warranty.
any thoughts? thanks
