Need part # or size for snout bolt/push-pin

[Torch Red 10th]

I swapped out my pulley a while back. I have a final run 2003 Cobra so it had the plastic push-pin in the snout instead of the bolt. I completely destroyed the plastic pin when I took it out for the swap. You wouldn't believe how tight that thing was in there. I recently noticed there's a lot of sand/grit/dirt in the threads inside the hole where the pin had been. I'd like to get a stock bolt or new plastic push-pin to put in there to keep any more crap from getting in there. It would make future pulley swaps easier and it would also be needed for trips to the dealer. Anyone know the part #'s for the bolt or push-pin or at least the bolt size.

Thanks guys

 

[wuplash]

if i remember correctly it's a 8mm bolt.i'am sure someone can take there bolt out and measure the length for you.