Neutral Saftey Question for Auto Swap

[bradfield]

I recently purchased a Cobra with a 4R70W swap, getting the car ready for the track and I have some questions on how to get the neutral safety working. Do I just add the Ford shift position sensor and tie it into the wires under the dash left over from the clutch, or do I get a neutral safety micro switch for my B&M shifter?

TIA

 

[PACIFICGREENSVT]

Micro switch on the B&M shifter, then run some wires down to the clutch pedal switch. Its that easy.

 

[VA-Mach1]

In your case with a B&M shifter get the micro switch and run it to the clutch pedal switch. That would be the easiest. I used a stock shifter on mine so I used the Ford sensor on the side of the trans and wired it to the clutch pedal switch.

 

[bradfield]

Thank you for the responses. I just dropped the car off with Triangle Speed Shop for a new tune, and some minor fixes, I just went with the Ford position sensor. If that is an issue I'll put the micro switch on myself.

 

[VA-Mach1]

The Ford switch will work the reverse lights too.