Ok got the snake Dynoed yesterday and came up with some good #'s but the A/F is RICH at 4500 to 6000 rpm...
MODS: Bord over .20 block
CAI, AccFab, 2.8 pulley with all 100mm Ids. Napa belt 840
Kook LT with custom O/R X pipe 2 1/2" to FlowMasters
2 1/2" to 3" tips and a Perdator custom tune...(By
Willy from Diablo sport at the Dyno)
Dyno: 466.6rwhp and 497.7 rwtq
A/F @ 4k:12.5-1
A/F @ 45K: 11.5-1
A/F @ 5k: below 10-1
A/F @55k: 10.2-1
A/F @6k: 11.1-1
If some one could host my Dyno graff so all could see PLEASE..
The tunr told me it could be belt slip...(I had the stock belt on before the put the Napa belt 840 and ran this. He told me he was going to put it back to 0 A/F on the Predator) Should I lean it out? If I do lean it out, By how much. It is set at 0 A/F right now....?
MODS: Bord over .20 block
CAI, AccFab, 2.8 pulley with all 100mm Ids. Napa belt 840
Kook LT with custom O/R X pipe 2 1/2" to FlowMasters
2 1/2" to 3" tips and a Perdator custom tune...(By
Willy from Diablo sport at the Dyno)
Dyno: 466.6rwhp and 497.7 rwtq
A/F @ 4k:12.5-1
A/F @ 45K: 11.5-1
A/F @ 5k: below 10-1
A/F @55k: 10.2-1
A/F @6k: 11.1-1
If some one could host my Dyno graff so all could see PLEASE..
The tunr told me it could be belt slip...(I had the stock belt on before the put the Napa belt 840 and ran this. He told me he was going to put it back to 0 A/F on the Predator) Should I lean it out? If I do lean it out, By how much. It is set at 0 A/F right now....?