New numbers coming soon finally

[Fenixfire]

Ill be installing some new mods in august. Im curious how much the car will make.

I made 486 rwhp and 490 rwtq SAE with the following:

Unported eaton with 3.1 upper and stock lower
Stock cams advanced 4 degrees
10.1:1 compression
.030 over bore
1 & 5/8" longtubes with 3" collectors and an o/r X pipe
Stock catback (mufflers cut off and 2.5" straight pipe welded in)
C&L CAI w/ 110 mm MAF
91 pump gas

New mods are:

Unported eaton with 2.76 upper and stock lower
98 cobra intake cams advanced 4 degrees
10.1:1 compression (unchanged)
.030 over bore (unchanged)
Longtubes and o/r X pipe unchanged but adding new magnaflow magnapack catback
Still 91 pump gas

I know it should make somewhere in the 500s. What do you guys think it might hit?

Chris at Dyno Edge tuned it before and will be tuning this new setup again.

 

[Fenixfire]

Wow, I posted this almost a year ago.........well I finally have all the parts and the car is going down in the next 4 weeks(waiting for the heads).

Going to have:

Posi ported eaton with a 2.49 upper pulley
Division X Dual bearing idler set
MMR Stage 3 ported heads, bronze guides, half mm oversized stainless steel forged valves, 5 angle valve job, manley springs, new seals and retainers
98 cobra intake cams advanced 4 degrees
10.1:1 compression ratio
.030 overbore
Melling billet geared oil pump
Stewert high volume mechanical water pump
03 Cobra tank with twin Ford GT pumps
60 lb injectors

Shooting for over 130+ trap speeds in the quarter at 5300 ft above sea level

 

[b_dike]

Wow! That is a really high compression number for a FI engine... What pistons are you using? What else is done to it?

 

[Fenixfire]

Wow! That is a really high compression number for a FI engine... What pistons are you using? What else is done to it?

Not really....I think 8.5:1 is too low.

It has a built bottomend already. Existing mods are:

Manley forged flat top pistons
Manley forged H beam rods
Kellogg forged crank
Canton windage tray
ARP Everything......head studs, cam bolts, harmonic balancer bolt, rod bolts, etc....
Pacesetter 1 and 5/8" longtube headers with 3" collectors
Off road X pipe
Magnaflow magnapack catback
Centerforce billet steel flywheel
Spec stage 3 Clutch
D&D Performance 3650 5 speed

 

[Anabolic]

do you have fuel mods?

 

[Fenixfire]

do you have fuel mods?

Currently, I just have an svt focus pump and 39 lb injectors. Part of the new build will be a cobra tank with twin ford gt pumps, a modified fpdm and 60 lb injectors. Should be more than enough fuel for a ported eaton. Eventually, ill upgrade the stock rails and lines, but dont need it right away.