New numbers

[sb306]

Well, its been awhile. But, it has finally been dynoed with the new combo. Stage 3 heads and stage 2 cams. 60 lb injectors 4 lb. lower and a stage 4 stieg ported eaton. It pushed 470 hp and 534 ftlbs at about 11.7 lbs of boost and a a/f of 11:1. The engine is still pretty tight so after a few thousand miles I'm going to put a 8lb lower on it and get the tune closer to 11.5:1. The numbers before the heads and cams were 418/488 and it peaked at 15 lbs of boost. Im hoping to be close to 500/600 with the 8 lb lower. woohooo. Nice to not be stepping on eggshells anymore with a stock block :dancenana:

 

[whiteonblackL]

haha congrats on the numbers man.what heads what cams? who did the engine

 

[CHUXSVT]

very good #'s for your blower/pulley combo. congrats.

 

[Rook]

i got 475 with 550 tq . going back next week after installing my long tubes and mid pipes

 

[sb306]

thanks guys. The heads are from DMP which are patriot castings with upgraded hardware/springs. The cams, I actually dont know the specs on them. It has some lope to it though. :burnout:

 

[MMShaggy]

Can't wait for the day when I no longer am walking on egg shells.
congrats. nice numbers for that pulley combo.