"now"1 coil cut and 2 leafs removed!

[04troublez]

before

after

 

[Zak Attack]

VERY NICE. It looks great now.

 

[throttle jockey]

:thumbsup:
Much better now.

 

[slammedi'am]

looks good

 

[87vertgt]

talk about a Money saving mod.....


I like....

are you using a camera phone?

 

[INFAMOU$]

A lowered L is a Happy L

 

[x_man586]

Were you at stock ride height before. I lowered mine 1" 2", but want it a little lower

 

[WhiteLight01]

Looks good. :coolman: I have the JLP shack's on mine set in the 2" hole. Would love to lower a bit more like this, especially the front.

 

[Zak Attack]

mine measured 28 or 29 inches from the ground to the top of the fenderwell. I think the back was 29 or just a hair over.

 

[04troublez]

yea i took the pics with ma phone. Before it was just sitting on 2'' shackles

 

[bird_jenkins8]

Looks damn good!!!!!!

 

[04troublez]

when it had full springs it rode hard but it rides smooth, all i need is get it align

 

[INFAMOU$]

mine measured 28 or 29 inches from the ground to the top of the fenderwell. I think the back was 29 or just a hair over.

My front is 28" and rear is 28.5"..

 

[qurtrn10]

So if I wanted to run by the performance shop and ask them to cut out one coil and remove two leafs, is there anything else I'd have to ask them to do (assuming I'd get an alignment right after)? This would be a temporary setup until I could afford the TVS system. Other than ride quality, are there any big negatives on doing it this way?

Miguel, it looks great!

Thanks,
William

 

[Zak Attack]

If you have any other lowering mods in the back then you need to either take them off or remove 1 leaf.

If your rear is stock, then pull 2 leafs and get some shackles and put them on the 1'' setting. The fronts you will want either one coil out or maybe more. I bought JDM Spring that have 2 coils out for a 3 inch drop and the isolaters in.

 

[gen2lightning]

looks bad ass bro!

 

[04troublez]

yea i think any shop could do that.