Hey guys I installed a 04 Cobra IRS in my Mach1 last February. At the time of the swap we changed pinion flanges so he could keep his alluminum driveshaft. Now I bought a alluminum driveshaft from a 04 Cobra and a new pinion flange because I was going to put a T56 in it. Well I git ripped off on the T56 (long story) so I want to use the drive shaft with my T3650 tranny. Does anybody know what ujoint I will need to connect my stock tranny yoke to the 04 Cobra driveshaft? It could possibly be the same ujoint and different yokes, I don't know. Thanks
O4 Cobra Driveshaft question
- Thread starter gaazuremach1
- Start date
I believe it's precision u-joint 440 which is a hybrid ujoint that has series 1330 on one side and series 1350 on the other (I think those are the right numbers... going off of memory). They sell them at Napa. It will allow you to use your 3650 slip yoke with the cobra driveshaft.
It's precision u-joint part number 448. I got mine from summit to connect the 04 driveshaft to my solid axle when I did my T56 swap.
CY98Cobra said:
Right.. 448. My bad.
Users who are viewing this thread
