p-codes after uploading new tune to new setup

greenstanggt99

Member
Established Member
Joined
Jun 20, 2008
Messages
235
Location
Georgia
I just installed a 2.3L whipple with 3" upper 4# lower, with 60# fuel injectors, a ba2400 MAF, single blade throttle body, and already installed BAP. I uploaded a 93 octane tune I received via my predator and now I get check engine light with the following p-codes, any suggestions as to why and how to resolve? i put in a note to the tuner and am waiting to hear back... I also forgot to mention i have an offroad xpipe with MAC catback exhaust. below are the specs for the tune...

P0602
P0135
P0155
P2195
P2197

Timing:
-Tune1 - 15 degrees max at WOT. You must run at least 93 octane fuel with this tune. I recommend only using this tune if you can't get (or make) 95 octane fuel. Running 15 degrees of timing at WOT will put undue heat on your exhaust valves and can burn them over time.

AirFuel: 11.8 commanded WOT A/F.
Idle: 786 RPM
Rev Limiter: 700 rpm
Speed Limiter: 255 mph
Fans: 20 degrees cooler than stock
Boost by-pass: Disabled
Shift Light: Will never come on.
Traction Control: Disabled
Rear o2 sensors: Disabled
Differential Gears: Stock
MAF: ba2400
Injectors: 60#
Calibration: HSF0
 

Users who are viewing this thread



Top