Parting out 99 Cobra Motor w/forged internals

99Venom

I ♥ Internal Combustion
Established Member
Joined
Oct 1, 2004
Messages
339
Location
Maine
***UPDATE***

Last August I spun (4) rod bearings in this motor. I've taken it completely apart and I'm looking to get rid of everything here. The engine ran smooth and normal even after the spun bearings so there was no other damage that I can tell. It came out of a 99 Cobra.

The crankshaft is the only component that has any visible damage (the rod ends were not damaged), the (4) journals have bearing material on them. The cylinder bores and pistons have some scuffing due the piston slap at cold engine temps. Everything else looks good, but obviously I can't guarantee 100% the condition of anything so look at the pics and make your own judgements.

Stock 8-bolt forged cobra crankshaft - SOLD
Wiseco forged pistons (for .030" bore & 10:1 CR) - SOLD
Eagle forged H-beam rods - SOLD
Teskid aluminum block (bored .030" over) - SOLD
Stock aluminum heads complete - SOLD
Cobra valve covers - SOLD
Stock lower intake w/stock injectors & fuel rail - SOLD


Cobra Motor Slideshow by dw8649 | Photobucket

PM if interested in any of the above.
 
Last edited:

99Venom

I ♥ Internal Combustion
Established Member
Joined
Oct 1, 2004
Messages
339
Location
Maine
Heads, intake and valve covers are now listed on Ebay as well so please PM for the latest on availability.
 

99Venom

I ♥ Internal Combustion
Established Member
Joined
Oct 1, 2004
Messages
339
Location
Maine
Update - Heads have been sold, the only part still available is the lower intake
 

Users who are viewing this thread



Top