ABS module (either ECU or both HCU/ECU) available?
I'm parting out everything on my car down to the frame. Read my sig carefully as it lists the mods in them. Besides that all the stock parts like dash, mirrors, visors etc are on the car.
Car has 65k miles on it. Most items have 5-10k miles on them that are aftermarket.
Engine
($4000) +2000hp Rotating Assembly (Package)
Complete Rotating Assembly Balanced
4.6L Modular 4V 5.0L Stroker Kit
Kellogg Stroker Crank
Manley Lightweight Competition Stroker Billet Rods
CP -23 Dush +.020 Bore Pistons
Stainless Steel File Fit +.020 Rings
King HP Main Bearings
King HP Rod Bearings
Melling High Volume Magnesium Housing Oil Pump /w Billet Housing
High Capacity Windage Tray
($650) Complete Heads
($600) Stock short block (cyl 2 melted)
($500) Teksid Block bored .020 over and decked
Eaton Setup (Full package)
($1500) Posi Race Ported Supercharger Throttle Body & Plenum, Stock Pulley, Lower Intake, Intercooler
Velocity gaskets and heat shield pads on the lower intake.
Stock intercooler pump & wires + fluid lines
Stock Intercooler Tank
Heat Exchangers
($300) Velocity Stage 3 - Rough Shape, Holds fluid 100% under pressure.
($150) Afco - Rough Shape, Holds fluid 100% under pressure.
Accessories
($125) Alternator
($425) Timing Cover /w All Attachments
($100) Crossover Tube
Turbo
($1200) Borg Warner T4 ST78 1.10A/R Turbo
($170) Greddy Profec Type-S Controller
Fuel System (Package)
($1700) x3 Walbro 255lph GSS342 Return Pumps
CPR Fuel Rails
FRPP 80# Injectors
Fore Triple Return Hat
MagnaFuel 2k HP Regulator
8an Feed & Return Lines
Rear End (Package)
($1200) 98 GT 8.8 Solid Axle (welded axle tubes & poly bushings)
Built GT500 Differential (spyder gears and clutches)
Moser 31 Spline Axles
Moser 2" Studs
FRPP 3.27 Gears
Drilled & Slotted Rotors
GT Brake Calipers
Tuning
($250) ECU Locked to SCT Xcal3
($175) SCT Xcal3 Locked to the above ECU
($150) N2MB 2-Step/Wot Box
Weight Reduction
($400) Corbeau TRS Seats
($100) 5 Point 4" Camlock Racing Harness
($100) Rear Seat Delete Kit
($75) Battery Trunk Relocation
Suspension
($500) UPR Tubular K-Member & Coilovers
($200) Front Bilstein Struts
Exhaust
($300) 2.5" SLP Loud Mouth 1 Cat-Back
Electronics
($70) FPDM
($300) PCM
($200) Gauge Cluster
Body
($350) Side Mirrors (black)