Hey everyone im getting some PI heads for my 98 and I want to know what angle valve job should be done? 3-angle valve job or 5-angle valve job not sure what to get done. Anyone know what I should get them ported at? :beer:
Port and Polish?
- Thread starter 98gtstang
- Start date
Here's your reply. I'm interested in the same question though.
If you are going to get it done, might as well go all out with the 5 angle valve job. Not too sure how much porting you want done. The more you port, the more torque is lost on your low end.
Fox lake
steen racing
TEA
are just three that do porting work.
Let the machine shop decide what valve job to do.THey should know best.
steen racing
TEA
are just three that do porting work.
Let the machine shop decide what valve job to do.THey should know best.
Users who are viewing this thread
