Ported Eaton, 80lbs

Nickrap9

Member
Established Member
Joined
May 11, 2013
Messages
83
Location
OKC, OK
Hey guys,

Finally got around to putting some upgrades on my Termi. I need to get a base tune going so I can get it dyne tuned. I'm using SCT Advance III with a SCTSF3 Flashtuner. Was hoping someone could give me some advice on fuel tables, etc. I'm running pure 93 octane right now and want to get an E85 tune in the near future. Right now the car has bit of a swinging idle and rough with crackle and popping out the exhaust. I know it running way too rich. My upgrades are as follows:

POSI Eaton with port matched Dragon plenum/SBTB
2.76 upper, snub and 4 piece idlers, 4lb lower, 3.2 alt.
80lb injectors
Dual GT Supercar pumps (still returnless)
40amp BAP
BA2600
JLT RAI
NGKTR6 gapped to 0.32
BBK long tubes with O/R mid
EGR blocked off

Any help would be greatly appreciated! :beer:
 

01yellercobra

Well-Known Member
Established Member
Joined
Oct 5, 2005
Messages
21,323
Location
Cali
Did you already write a base tune for the new MAF and injectors? If so you need to dial in the MAF transfer first. Everything is based off that being dialed in correctly.
 

Users who are viewing this thread



Top