possible trade 2010 gt500 for 03/04

NeverFastEngh

Active Member
Established Member
Joined
Apr 13, 2008
Messages
2,921
Location
Winchester VA
Im in VA and have a 03 black coupe. Info below

2003 Black Cobra coupe #1141

-64k original miles clean title
-Boss 330 short block
-Fox lake ported heads
-Comp stage 3 blower cams and springs
-Kooks long tube stainless headers/3" stainless exhaust
-3.4 whipple
-60lb injectors
-BA 2800 mass air
-CPR rails
-Canton pan and windage tray
-All of engine powdercoated wrinkle black
-Canton expansion tank
-LFP IC tank
-Twin walboro 342's -10 feed and -8 return
-Mcleod twin disk clutch/ flywheel
-Liberty Viper spec T56 MGW shifter
-Strange 4" chromoley drive shaft with chromeoly yokes
-Custom braced 8.8 with 33spline pro race strange axles, c clip elim, and spool
-Precision race cut 4.10 gears
-UPR race upper and lowers
-UPR K member, a arms, and coil overs
-Taylor trunk battery mount
-Lunar Oil, boost, and fuel guages
-04 Dark insert seats
-Through floor frame rail conectors
-Ice cold AC


-Made 662 on a 2.3 whipple on pump gas. Havent dynoed with the 3.4 yet. But with the same tune and same boost pulling 6 degrees of timing out of it too be safe it went 10.42 at 142mph with a 1.88 60' spinning its ass off.
 

gtmuscle

New Member
Established Member
Joined
Sep 10, 2006
Messages
450
Location
Tampa
how about an 03 silver anniversary edition coupe with 16,000 miles and the following mods:

Steggy stage 5 ported blower
Ported dragon plenum
6lb metco lower pulley
2.80 metco upper pulley
snub idler pulley
62 lb injectors
2400 MAF
JLT ram air CAI
fluidyne heat exchanger
magnaflow o/r x pipe
magnaflow catback polished
steeda subframe connectors welded
h&R race springs
Tokiko shocks
MGW orange handle shifter
deep dish 17" anniversary repilica wheels
nitto NT05 with 300 miles
SSBC slotted rotors with hawk pads and SS lines
SCT tuned
 

Users who are viewing this thread



Top