I dig them both. Great choice
-J
-J
I keep a lint roller in the GT 500, especially good for the black carpet.
Those look clean. I dig it.Also installed color-matched Heat Extractor Covers from MMD. Instead of venting out the top, they vent out the back. They also give the hood a cleaner look from the front.
Some colors are still on sale. Think I paid $125.
MMD Mustang Hood Vents; Pre-Painted 405256 (18-22 Mustang GT, EcoBoost) - Free Shipping
FREE SHIPPING! Intimidating Style. A set of MMD's Pre-painted Hood Vent Scoops will add a more intimidating appearance to the front of your 2018-2022 Mustang. Awww.americanmuscle.com
From what I can determine, the overall airflow exiting the engine bay does not change.
Again, super simple install. There's a couple of small pieces of 3M automotive tape, and you switch over some mounting brackets from the stock ones.
They went on perfectly. Color match is also excellent.
Before:
View attachment 1797153
After:
View attachment 1797146
View attachment 1797154
View attachment 1797155
Those are nice.Brushed Stainless Steel Dead Pedal Plate, Made in USA by American Car Craft.
If you're ordering for '15-'22 Mustang and want it to match your stock pedals, be sure to order the "brushed" model, not polished.
Looks great, matches the pedals perfectly.
Before:
View attachment 1798889
After:
View attachment 1798888
Can be purchased from multiple sources.
Here's the Amazon linky:
Those are nice.
North of Tampa a little.They're manufactured down in your neck of the woods too, Hudson, FL.
Replaced the A-pillar door jamb tape with a rubber plug from LMR.
View attachment 1837999
View attachment 1837996View attachment 1838000
Put a drop of lube (I used tire shine) on the rubber plug, it’ll push right in.
Pic of tape & plug:
View attachment 1838001
Background:
A few owners of S550’s have identified wet carpet on the floor of their cars (both sides).
Turns out that prior to painting S550’s, Ford applied 1-1/2” diameter piece of tape over a 3/4” hole on the A-pillar door jamb. On some cars, that tape was either poorly placed and/or it became separated from the A-pillar, allowing water to enter the cabin.
link to source:
I’m sure this sort of thing has gone on for years across many manufacturers, but holy hell that’s lazy.
I’d suggest $6 for $.10 worth of rubber is robbery, but whatever, everyone gets their piece.