Ive been reading quite a bit, but I am still on the fence and just want to make sure before i purchase my fuel parts.
First off, my motor is a 10.2:1 compression built teskid, and i am running a 2.2 KB. I am wanting to do one aeromotive a1000 pump, eliminator sumped tank, -8 line and some 80lb injectors. I already have the aeromotive rails. I know i will need Y block, filters etc.....but my question is will this be enough on E85 ? i know i have a 2.2 blower, and with longtubes i am going to push about 19 lbs so the motor sees 17, i was told this was enough on my compression to make well over 650.
Thanks guys, just wanted to make sure i was not missing something. I see all this and that about 105 lb injectors, two a1000 pumps etc. etc, however im not pushing 25 psi on a 2.8h haha.
thanks again
First off, my motor is a 10.2:1 compression built teskid, and i am running a 2.2 KB. I am wanting to do one aeromotive a1000 pump, eliminator sumped tank, -8 line and some 80lb injectors. I already have the aeromotive rails. I know i will need Y block, filters etc.....but my question is will this be enough on E85 ? i know i have a 2.2 blower, and with longtubes i am going to push about 19 lbs so the motor sees 17, i was told this was enough on my compression to make well over 650.
Thanks guys, just wanted to make sure i was not missing something. I see all this and that about 105 lb injectors, two a1000 pumps etc. etc, however im not pushing 25 psi on a 2.8h haha.
thanks again