Replacing all Ball Joints

[Bootbox]

I'm going to switch to Belltech spindles up front (just ordered them) and I figure while I'm in there putting the stock arms back on I might as well do all new ball joints too.

What choices do we have? Anything greaseable options for the stock arms? I seem to remember needing to get all new arms if you wanted to use Moog ball joints... is that the case?

 

[miamijdm]

hey, are you going up at all, or your going to do the spindles and something else to stay at the same height? I have the spindles on my truck and they ride really nice.. When I went to do the alignment, they said I had to change my ball joints cause they were bad, so I got new ones..

 

[Bootbox]

Same height. I have lower control arms and coils now, the coils will stay in when the spindles go on. Can't wait to get the new setup with the new ball joints in. The front end's been getting looser and looser the last couple of months.

Anyone know if I can get greasable joints for the stock arms? oke:

 

[scv8]

Here you go:

Moog

Which route are you taking to get the spindles to fit the 18"s?