Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Driveline
Replacing Halfshaft CV Boots?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ShelbyGuy" data-source="post: 7265304" data-attributes="member: 10042"><p>good luck finding a boot, but if you can find one....</p><p></p><p>cut the clamps off the old boot</p><p>pull the joint off the tripod</p><p>with a set of retaining ring pliers [no i didnt say snap ring pliers] move the retaining ring down the shaft</p><p>push the tripod down the shaft</p><p>remove the circlip you revealed by moving the tripod down</p><p>slide tripod off end of shaft</p><p>slide boot off end of shaft</p><p>slide new boot on</p><p>put tripod back on</p><p>put circlip back on</p><p>move tripod back up</p><p>slide retaining ring back up</p><p>fill boot with grease</p><p>put joint back on tripod</p><p>install new clamps on boot WITH A BOOT CLAMP TOOL not end cutters.</p><p>throw half-shaft at car</p><p></p><p>240 lb-ft for the axle nut DO NOT USE AN IMPACT TO PRELOAD A BEARING</p></blockquote><p></p>
[QUOTE="ShelbyGuy, post: 7265304, member: 10042"] good luck finding a boot, but if you can find one.... cut the clamps off the old boot pull the joint off the tripod with a set of retaining ring pliers [no i didnt say snap ring pliers] move the retaining ring down the shaft push the tripod down the shaft remove the circlip you revealed by moving the tripod down slide tripod off end of shaft slide boot off end of shaft slide new boot on put tripod back on put circlip back on move tripod back up slide retaining ring back up fill boot with grease put joint back on tripod install new clamps on boot WITH A BOOT CLAMP TOOL not end cutters. throw half-shaft at car 240 lb-ft for the axle nut DO NOT USE AN IMPACT TO PRELOAD A BEARING [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Driveline
Replacing Halfshaft CV Boots?
Top