Keeping the FPDM in place, what should I use at the Trigger wire for Pump 1 so it primes and shuts off just like factory with Key On?
I found a thread talking about wiring up a Relay and using Pin 10 and Pin 3 out of the FPDM. Pin 10 being Pump Power and Pin 3 being Pump Ground. Says use Pin 3 as the trigger.
However, I assume with the FC3, I would use Pin 10 -Pump Power- as a trigger wire for Pump 1 since it says it needs + 6.5 Vdc to trigger the pump.
I found a thread talking about wiring up a Relay and using Pin 10 and Pin 3 out of the FPDM. Pin 10 being Pump Power and Pin 3 being Pump Ground. Says use Pin 3 as the trigger.
However, I assume with the FC3, I would use Pin 10 -Pump Power- as a trigger wire for Pump 1 since it says it needs + 6.5 Vdc to trigger the pump.