rough idle after imrc clean

[sn925]

I just finished cleaning my imrc after I put everything back together I turned it on it was running fine then I went to pump some gas and give it a nice wot everything was good headed home till it started acting up rough idle and wanting to turn off any ideas

 

[bumsoil]

vacuum leak from the IMRC bearings/seals on the ends.

 

[sn925]

I didn't even know they had bearings/seals FML time to look for some deletes

 

[arayray]

I would let it sit and idle for awhile, my car was running very rough after I cleaned my IMRC but I attributed it to not putting the injectors back in their original spots.

 

[sn925]

I did have a hard time putting back the injectors in there place I double check that

 

[arayray]

Mine cleared up after letting it idle for atleast 30 mins for acouple times. Hope you figure your problem out!

 

[bumsoil]

it will sometimes run rough for a new minutes. ive had mine apart 4 or 5 times to try to rid the imrc plates of vacuum leaks. I even replaced them with used composite ones. I just live with my leak now.............................

 

[sn925]

So I looked at my injectors and they where loose and. Some looked like this

And I was looking around and seen a bolt missing from the lower intake one of the middle bolts the big ones I'm 100% sure it was there looks like I'm going to take it apart agian I'll keep you guys updated thanks for the response guys