- Joined
- Jan 14, 2017
- Messages
- 37
I seem to find so much conflicting information in regards to what driveshaft dimensions should be used when doing a t56 swap into a GT. Most of the shops that do the kits guard this information. So will somebody with a GT with solid rear axle and a custom driveshaft measure from the center of your universal joint to universal joint and put to bed the question what driveshaft? , The most common idea is 1 inch should be cut down from your GT drive shaft which is 451/2 inches . So if that information is correct I should need 44 1/2 inches which is the same driveshaft length the 2001 cobra uses sR performance sells the driveshaft on American muscle.com at 44.5 inches .but I would like to confirm this from somebody who had a custom driveshaft made it before purchasing
Sent from my iPhone using the svtperformance.com mobile app
Sent from my iPhone using the svtperformance.com mobile app