Kooler731
New Member
Evening everyone
Well my coyote swap has hit its first wall.
Engine will not turn over with the key.
when you turn the key on everything else works and self checks ok. (Abs, pats, radio, ect...)
The engine just will not turn over with the key, I can jump it at the 1 wire breakout plug by the battery and it turns over.
Swapped relays in PDB, jumped the clutch safety switch, and most normal mustang stuff I have seen or dealt with in the past.
back story of the car was engine was damaged before I got it. I started it and pulled it into the shop and removed the old engine for the coyote swap. All harnesses were unplugged and reused except engine 42 pin harness (depinned everything except oil switch, coolant temp, ac clutch and ground) everything else is in the car.
What wire off the ign switch do I need to probe to check for power under starting?
anything else anyone can point out to me to check?
thanks in advance
Well my coyote swap has hit its first wall.
Engine will not turn over with the key.
when you turn the key on everything else works and self checks ok. (Abs, pats, radio, ect...)
The engine just will not turn over with the key, I can jump it at the 1 wire breakout plug by the battery and it turns over.
Swapped relays in PDB, jumped the clutch safety switch, and most normal mustang stuff I have seen or dealt with in the past.
back story of the car was engine was damaged before I got it. I started it and pulled it into the shop and removed the old engine for the coyote swap. All harnesses were unplugged and reused except engine 42 pin harness (depinned everything except oil switch, coolant temp, ac clutch and ground) everything else is in the car.
What wire off the ign switch do I need to probe to check for power under starting?
anything else anyone can point out to me to check?
thanks in advance