Got the itch to get the car running again, can't wait to run this setup...hermann :thumbsup:
Replaced the iron block with a teksid 96 cobra block i had laying around, used the stock crank, with a custom C-P piston that is .020 over and a good set of replacement H beam rods. I bowl ported the heads myself, replaced the valves with stainless and used crower brand springs, keepers and retainers. Topped the valvetrain off with a set of custom cams we had ground to our specs. Canton pan was added for extra oiling and oil control. Using a metco x-10 drive system with the huge 10" lower you see in the pics...that's all i have in this simple engine...no stroker needed here... :thumbsup: Going to post pics up maybe tonight with the blower stuff on....hermann :beer:ShelbyGuy said:but they all have those parts on the outside! show us pics of the inside!
and where are the specs for us to drool over?