STB measurements

[mach1gsxr]

Can anyone help me out here and give me the O.D. and wall thickness measurements of a stb for any mustang that they have it installed on or waiting to install it on. I use to have the Steeda one but it did not fit over the JLT intake so I sold it. Now I want another one and will have to make it myselft but would like to keep it to similar dimensions to the other units out there.

Thanks in advance for the help.

 

[mach1gsxr]

bump

 

[birdman941]

I read somewhere that the Steeda 3 pt. will work,
but you have to mod the center bar and weld it.
May have been on the org.
It's been a while.

 

[mach1gsxr]

I read somewhere that the Steeda 3 pt. will work,
but you have to mod the center bar and weld it.
May have been on the org.
It's been a while.

Thanks, but I would much rather fabricate my own then worry about buying a 140 dollar piece then cut on it and reweld it and then have to get it powdercoated again. I will end up spending probably close to 200 or more at least.

By making my own I can fit it over what I want and how I want for less than half the cost.