Would like your input please
Ok here is my attempt @ this. I would like your input, as far as it being safe, looking okay,and if there anything you would change if you done it???
I use two 10ga wires, with heat-shrink tubing where it goes through the hat. Then applied the JB-Weld to the Prepped hat(ground down/sanded,surface cleaned). All the other spade fittings are double heat shrunk as well.
I never seen pics of anyone elses install, so i figure i would give it a try, as i cant afford a Fore Hat right now :bash:
Ok here is my attempt @ this. I would like your input, as far as it being safe, looking okay,and if there anything you would change if you done it???
I use two 10ga wires, with heat-shrink tubing where it goes through the hat. Then applied the JB-Weld to the Prepped hat(ground down/sanded,surface cleaned). All the other spade fittings are double heat shrunk as well.
I never seen pics of anyone elses install, so i figure i would give it a try, as i cant afford a Fore Hat right now :bash:
Last edited: