I'm swapping the stock sc pulley to a metco 2.5. I just pulled the pulley off after some time, but the large middle welded bolt just turns clockwise and counterclockwise without moving in or out at all. How do I remove this? Is it suck?
Supercharger Pulley Tool Won't come off
- Thread starter Welfare
- Start date
Bump, any help greatly appreciated
I picture would help.
Did the stock pulley come off, are you referring to the centre bolt on the puller?
Did the stock pulley come off, are you referring to the centre bolt on the puller?
I'll go snap a pic quick. The stock pulley is off, but just dangling on that center bolt.
This is my current problem.
Last edited:
not sure how to post an image.
http://www.svtperformance.com/forums/showthread.php?785405-Pulley-Puller-stuck
Same problem as that, but I need a solution
http://www.svtperformance.com/forums/showthread.php?785405-Pulley-Puller-stuck
Same problem as that, but I need a solution
Last edited:
Got it. Had to use a high-power impact gun and some lubricant. The last couple threads of the large bolt were mushroomed out, so I had to take a bandsaw to it and ground it to re-thread the nut off/on.
It would be a safe bet for you to check the pulley snout for any deformation as well
It seemed fine, I checked it over after i pulled it off. I guess I'll know when the new one gets put on tomorrow
Users who are viewing this thread
