Hey guys,
Todd is out of town and sugested I give a try on the board here to see what I am doing wrong here.
I have apx 1/4" movement on the rear axel in the housing after putting it back together.
I used the stock C-clips when I put the axels back in.
I know Todd's are slightly wider but not enough to make up this 1/4".
Anyone have any advice on this before I pull the rear cover and slip in Todd's C-clips?
I have the Tru-trac in if that makes any difference.
Seems like it needs a larger piece of stock that seperates the axel ends inside the housing to tighten up the slack.
Any help will be appreciated.
I know some guys running this setup have it working so if you can let me know any tricks I am missing.
Thanks
Todd is out of town and sugested I give a try on the board here to see what I am doing wrong here.
I have apx 1/4" movement on the rear axel in the housing after putting it back together.
I used the stock C-clips when I put the axels back in.
I know Todd's are slightly wider but not enough to make up this 1/4".
Anyone have any advice on this before I pull the rear cover and slip in Todd's C-clips?
I have the Tru-trac in if that makes any difference.
Seems like it needs a larger piece of stock that seperates the axel ends inside the housing to tighten up the slack.
Any help will be appreciated.
I know some guys running this setup have it working so if you can let me know any tricks I am missing.
Thanks
Last edited: