Teksid block machine work

[lightninmike]

Ok guys I have been looking for this info for a bit but can't seem to find for sure. I have a 95 teksid engine that I am going to do a budget build on for my notch. The motor only has 60k on it but I'm going to convert it to 03 heads and cobra crank. Hoping I can get away with just a hone but if I have to bore the cylinders do I also need to put new sleeves. Or can the stock sleeves be machined. Thanks for any info guys.

 

[mwolson]

You can go 0.020" or 0.030" over on a Teksid block without new sleeves.

 

[lightninmike]

Thank you very much sir. If I have to it will be as little as possible.

 

[mwolson]

I researched that for the Teksid block on my engine stand. Mine will be 0.020" over. (when I get around to finishing it...)

 

[96dreamer]

i would go over the smallest amount over possible. I just bought .010" over pistons, i would have went .005 but was uncertain the bores would clean up.