http://www.kijiji.ca/v-view-details.html?requestSource=b&adId=1099595074
That's the car Im pondering.
I have a motor sitting around that I was going to use for mock-up. Would have to get trans though, probably 3 spd auto maybe even a glide.
End goal being junkyard(ish) built turbo, engine would get some $.
Stripped interior(already started)
No wires anywhere other than those needed.(Painless kit)
Caged
UPR suspension parts
More a less a strip only car. That at some point in very distant future may make it back on the road.
Anyone gone through this with these cars please chime in, what should I look for as problem areas on the car?
Weak points common rust areas that are hard to see?
Any advice on the notch's little known but common problem areas would be a big help.
Thanks men
That's the car Im pondering.
I have a motor sitting around that I was going to use for mock-up. Would have to get trans though, probably 3 spd auto maybe even a glide.
End goal being junkyard(ish) built turbo, engine would get some $.
Stripped interior(already started)
No wires anywhere other than those needed.(Painless kit)
Caged
UPR suspension parts
More a less a strip only car. That at some point in very distant future may make it back on the road.
Anyone gone through this with these cars please chime in, what should I look for as problem areas on the car?
Weak points common rust areas that are hard to see?
Any advice on the notch's little known but common problem areas would be a big help.
Thanks men