TVS 2.3 & Supporting Mods - Fuel setup

[marshall_cobra]

I as well jumped on the sale for a VMP TVS 2.3 for my 03 cobra. The car is near bone stock (only 10K miles on car total) with exception to some of the basic bolt-ons.. I only plan to run 14-15 #'s of boost on her currently. I would like to see the car hit 550-580 hp to the wheels. Anyways ill list all mods below that i have ready to be bolted on. Give me some thoughts and opinions on my setup that i plan on running.. Yes i know thats low boost for this new supercharger but I am wanting to start off a little low and then build up to more when i have the proper fuel, clutch, and suspension upgrades. Will the fuel mods i have listed below be sufficient to handle under 600hp? i know its been labeled as a bandaid to use a BAP but what do you think?

Future plans will be to push about 650, no more.. Ill be on 93 pump.

PARTS READY TO INSTALL
VMP 2.3 w/gt500 TB package (3.2 Pulley/14psi)
JLT Cold Air Intake
SCT BA2600 MAF
60IB Injectors
KB Boost A Pump with Wire upgrade
Metco Dual bearing idlers (5pc)
SCT X4
Head Cooling Mod
170 degree thermostat
AFCO Heat Exchanger

PARTS ON CAR
Magnaflow catted X pipe
Stinger Catback
MGW Shifter
JLT Intake
315's on rear
(Stock Clutch for now)

 

[apex svt]

Sounds like you got it all covered for the boost level you’re going be running.
As for the bap, I’ve had it for over 3 years issue free. So has my buddy and tons of people on this forum.
Also does the kit come with gaskets?
Blower
Ic o rings
Ic gasket
Black rtv for the intercooler to blower.

Good luck!