So last night I began modding my 2012 GT as soon as I drove it home from the dealer 
I started with FRPP P springs and a Steeda "stop the hop pack".
When I ordered the Steeda control arms it listed for up to 2010 but I assumed it would be the same on 2011-12.
Lower arms bolted up fine, after I went to the pain in the ass task of getting the upper arm/mount out I took the arm off the mount and installed the new arm and the bracket on the Steeda arm where the bump stop mounts interferes with the stock chassis mount only allowing it to rotate to a certain point.
Looks like I'll be ordering an aftermarket chassis mount...
Is anyone else aware of this or had this problem?
I started with FRPP P springs and a Steeda "stop the hop pack".
When I ordered the Steeda control arms it listed for up to 2010 but I assumed it would be the same on 2011-12.
Lower arms bolted up fine, after I went to the pain in the ass task of getting the upper arm/mount out I took the arm off the mount and installed the new arm and the bracket on the Steeda arm where the bump stop mounts interferes with the stock chassis mount only allowing it to rotate to a certain point.
Looks like I'll be ordering an aftermarket chassis mount...
Is anyone else aware of this or had this problem?
