What are people running for rear Camber?

[Jaimie03Cobra]

I am running 2 degrees negative camber in the back from my last alignment. Is this what Cobras came with stock for a setting? The reason I ask is that when I launch at the track on my DRs it looks like I am launching on less than half of the tread by the wear. I am riding stock ride height in the back with only 13000 miles. I am running 17 by 10.5s with 18-20 psi normally. I drive around on 28-30 psi on the street. Just seems like I am launching on half of the tire. Should I try for a new alignment and ask for 0 degrees camber in the back like a solid rear?

Jaimie

 

[racebronco2]

Are you sure 2* neg camber. Most cobra's are lucky if they can get .7* camber without modifying the arms/eccentric bolt. You should have a little camber in the rear maybe .5* camber.

 

[vegaspackerfan]

I am running the rear at Negative 3/4 camber.

VPF

 

[hawaiiancobra]

i run a negative 1.2 degrees, those were kenny browns recommendation

 

[sonic cobra]

I run - 1.1 rear camber with coil-overs -.5 sounds good for a stock setup

 

[04SLOBRA1]

- .5

 

[jm@ReischePerf]

.75

 

[Jaimie03Cobra]

Thanks for the replies. I'm getting an alignment next week and would like to request less camber in the back. I'm going to try .5 or .75. I'll have to think on it.

Jaimie