Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
New Edge Cobras
What Forged Rod's and Piston's Should I Get?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DSG2003Mach1" data-source="post: 15595940" data-attributes="member: 16477"><p>but are those friends familiar with mod motors? Not that theyre rocket science but there are plenty of little things that can go majorly wrong or weak points wont be properly addressed </p><p></p><p>you need to have the block already cleaned up and machined to know what the final bore ends up </p><p></p><p>you need to establish a power goal, whats the absolute most youre gonna put it through to spec out the internals. Dont forget to factor in fuel type if a power adder how much boost/nitrous itll see to determine compression ratio. There are several good manufacturers including Diamond and a lot of people seem to like Gibtec (sp?) for rods you could end up with anything from terminator or boss rods to maybe something like Molnar. Again, lots of choices but more info is needed for anyone to give you better guidance</p></blockquote><p></p>
[QUOTE="DSG2003Mach1, post: 15595940, member: 16477"] but are those friends familiar with mod motors? Not that theyre rocket science but there are plenty of little things that can go majorly wrong or weak points wont be properly addressed you need to have the block already cleaned up and machined to know what the final bore ends up you need to establish a power goal, whats the absolute most youre gonna put it through to spec out the internals. Dont forget to factor in fuel type if a power adder how much boost/nitrous itll see to determine compression ratio. There are several good manufacturers including Diamond and a lot of people seem to like Gibtec (sp?) for rods you could end up with anything from terminator or boss rods to maybe something like Molnar. Again, lots of choices but more info is needed for anyone to give you better guidance [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
New Edge Cobras
What Forged Rod's and Piston's Should I Get?
Top