Which cams for my 03 Mach 1?

[ForceFedFan]

I'm getting ready to drop a NA Aluminator long block in my 03 Mach 1. After seeing the crappy specs for the stock cams I decided to try to find a deal on something to give me a little better performance to put in before I put the motor in the car. I'm planning on adding long tube's, pulley's and a dyno tune on the car in addition to the cams. I found a pretty decent deal on a set with new springs and new titanium retainers but I'm afraid they may be a little too aggressive for a non-forced induction, daily driven car. Any opinions or suggestions would be greatly appreciated. They're the Crower stage 2's, from the looks of the spec's I'm going to be giving up a lot of bottom end. I have a Nitrous Express Blackout kit I can put on the car but that's obviously not for everyday driving.
Adv duration: 252/252
Adv duration @ valve: 264/264
Duration @ .050" lift: 206/206
Duration @ .050" @ valve: 222/222
Lobe lift: .264/.264
Rocker ratio: 1.8/1.8
Gross valve lift: .475/.475
Peak HP: 6,400
Redline: 6,900
Lobe separation angle is 114 degrees.

 

[na svt]

what's the performance and power goal?

Ti retainers are not needed on engines.