This isn't getting much attention in the Turbo Cobra Section so I am opening it up a bit.
What RPM are you leaving from?
Are you using a two step?
How much boost are you building at the line?
Are you spraying?
Also the car is a Hellion T76 car.
My setup:
01 Bullit 8.8
Moser 33 Spline Axles
Moser Spool
C-Clip Elim.
Welded tubes
UPR Chrome Moly Adj. Race Lowers
UPR Chrome Moly Double Adj. Race Uppers
UPR Spherical Bushings
UPR Anti-Roll Bar
UPR Rear end Stud Girdle
ARP Hardened Studs
Weld Prostars 15x10/15x4
Hoosier QTP 27x11.5x15 (Just to see what I go through the traps, most likly bumping to a 28")
Also for the fronts skinnys what needs to be done to make them fit? I vaguely remember reading that you need to get a spacer and grind the caliper? Any help there would be great!
What RPM are you leaving from?
Are you using a two step?
How much boost are you building at the line?
Are you spraying?
Also the car is a Hellion T76 car.
My setup:
01 Bullit 8.8
Moser 33 Spline Axles
Moser Spool
C-Clip Elim.
Welded tubes
UPR Chrome Moly Adj. Race Lowers
UPR Chrome Moly Double Adj. Race Uppers
UPR Spherical Bushings
UPR Anti-Roll Bar
UPR Rear end Stud Girdle
ARP Hardened Studs
Weld Prostars 15x10/15x4
Hoosier QTP 27x11.5x15 (Just to see what I go through the traps, most likly bumping to a 28")
Also for the fronts skinnys what needs to be done to make them fit? I vaguely remember reading that you need to get a spacer and grind the caliper? Any help there would be great!